Tachometer Inaccurate (Beretta & Corsica)
- Disconnect Direct Ignition System (DIS) electrical connector. Plug IPC Tester (J-33431) into a wall outlet. Connect Harness Connector (J-33431-10) from tester to DIS connector terminal "F" (VIN A), "A" (VIN 4) or "C" (VIN T).
- Set tester controls to 60 HZ and 54 MPH. If tachometer indicates 1800 RPM (4-cylinder) or 1350 RPM (6-cylinder), check for clean and tight connections at DIS connector. If DIS connector is okay, replace DIS.
- If tachometer does not indicate 1800 RPM (4-cylinder) or 1350 RPM (6-cylinder), check DIS White wire for open circuit or a short to ground.