Intake Manifold: Notes
- Disconnect negative battery cable, and drain cooling system. Remove air cleaner and throttle body assembly. Disconnect ECM wiring harness, and set it aside. Remove upper radiator hose at thermostat and heater hose at intake manifold.
- Remove thermostat housing and gasket. Mark and remove necessary electrical connectors and vacuum hoses. Mark and remove necessary fuel line clips and lines. Remove throttle cable bracket. Mark and remove spark plug wires at distributor cap. Remove EGR valve and solenoid. Remove distributor cap.
- Mark distributor rotor position for installation reference. Remove distributor. Remove ignition coil and coolant temperature sensor. Remove A/C compressor brace. Remove intake manifold bolts and studs. Remove intake manifold and gasket.