LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1992 >> Caprice Classic LTZ >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 5.0L (305") V8 - VIN [E] >> Removal & Installation >> Cylinder Head >> Installation

Cylinder Head: Installation

  1. Coat steel-type head gaskets with sealer. DO NOT coat composition-type head gaskets with sealer. Install head gasket on cylinder block. Install cylinder head. Coat head bolts with Sealing Compound (1052080).
  2. Install head bolts finger tight. Tighten bolts to specification in 3 steps in proper sequence. See Fig 1 . To complete installation, reverse removal procedure.
Fig 1: Cylinder Head Bolt Tightening Sequence
G92G04242Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals