LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1990 >> Step Van 7.4 N, Standard >> Repair and Diagnosis >> Transmission >> Manual Trans >> Removal & Installation - M/T >> Transmission Removal & Installation >> All Models Except "S" & "T" Series >> Installation

All Models Except "S" & "T" Series: Installation

  1. Check that plugs located in rear of bellhousing below transmission mounting bolt holes are tight and not damaged. Note location before removal. Install new plugs if plugs are damaged.
  2. Apply a light coat of high-temperature grease to the main drive gear splines. Place the transmission in high gear. Install Guide Pins (J-1126) (if used). Reverse removal procedures to complete installation. Tighten mounting bolts to specification. Refer to TORQUE SPECIFICATIONS (ALL EXCEPT "S/T" SERIES) .
scientia non olet · About LEMON Manuals