NP-205 (V30/35) & NP-241 (V10/15 & V20/25): Removal
- Disconnect negative battery cable. Raise and support vehicle on hoist. Remove skid plate. Drain transfer case. Mark rear drive shaft components for reassembly reference. Disconnect and remove rear drive shaft from vehicle.
- Mark front drive shaft components for reassembly reference. Disconnect and remove front drive shaft from vehicle. Disconnect vent hose and electrical connectors from transfer case. Disconnect speedometer cable and shift linkage at transfer case. Remove transfer case strut rod (if equipped).
- Support transfer case and remove bolts attaching transfer case to transmission. Move transfer case to rear until clear of transmission. Lower transfer case assembly from vehicle.