LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1990 >> Step Van 7.4 N, Standard >> Repair and Diagnosis >> Transmission >> Manual Trans >> Overhaul - Gm 117 4-Speed >> Component Disassembly & Reassembly >> Drive Gear (Input Shaft) >> Disassembly

Drive Gear (Input Shaft): Disassembly

  1. Remove mainshaft pilot roller bearings from drive gear if not already removed. Remove roller bearing snap ring. DO NOT  remove snap ring on inside of drive gear. Remove snap ring securing bearing on shaft of drive gear.
  2. Remove bearing snap ring. To remove bearing from drive gear shaft, position bearing support tool under bearing. Using an arbor press, press bearing from drive gear shaft. Remove oil slinger.
scientia non olet · About LEMON Manuals