Cover & Shift Fork Assembly: Disassembly

1. Remove shift rod cover plugs. Drive out pins retaining 1st-2nd and 3rd-4th shift forks to shift rods. Note locations of shift forks and shift rods before removal. With shift rods in neutral position, drive rods out of cover. Remove shift forks.
2. DO NOT  lose detent balls, springs, interlock balls, pins and shuttles when removing shift rods. Drive out pin holding reverse shift fork, and drive out shift rod. DO NOT  lose detent ball when removing rod.

Fig 1: Exploded View of Shift Cover & Components ("C" & "K" Series)

Courtesy of GENERAL MOTORS CORP.

Fig 2: Exploded View of Shift Cover & Components ("R", "V" & "P" Series)

Courtesy of GENERAL MOTORS CORP.