LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1990 >> Step Van 7.4 N, Standard >> Repair and Diagnosis >> Suspension >> Front Suspension >> Suspension - Front (2WD Coil Spring) >> Removal & Installation >> Wheel Bearings >> Removal

Wheel Bearings: Removal

  1. Raise and support vehicle. Remove wheel and tire assembly. Remove brake caliper and hang aside. DO NOT allow brake caliper to hang by brake hose.
  2. Remove dust cap, cotter pin, spindle nut, washer and then remove hub and rotor assembly. Remove outer bearing, inner grease seal and inner bearing.
  3. Clean bearings and inspect bearing and races for damage. If races require removal from hub, drive old races from hub using a hammer and a brass drift inserted through notches of hub.
scientia non olet · About LEMON Manuals