Stabilizer Bar: Removal
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1990 GMC Suburban, 1990 GMC Pickup, 1990 GMC Jimmy, 1990 GMC Cab & Chassis, and 1990 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support vehicle on frame hoist. Detach nuts and bolts attaching stabilizer brackets and bushings at frame locations. Detach pivot bolts and washers at lower spring anchor plates. See Figure .
- Remove stabilizer bar from vehicle. Inspect rubber bushings for excessive wear or deterioration. Check bar for damage. Replace components as necessary.