LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1990 >> Step Van 7.4 N, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (SUSPENSION - FRONT ( C Series 2WD)) >> Removal & Installation >> Stabilizer Bar >> Removal

Stabilizer Bar: Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1990 GMC S15 Pickup, 1990 GMC S15 Jimmy, 1990 GMC Pickup, 1990 GMC Cab & Chassis, and 1990 Chevrolet S10 Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support vehicle. Remove bolt and link bushing assembly from each side of stabilizer bar. See Figure . Components should be marked for installation in original location.
  2. Remove bracket-to-frame (or body) mounting bolts. Remove stabilizer bar with rubber insulator bushings and brackets. Inspect insulator bushings and link bolt grommets for damage or deterioration and replace as necessary.
scientia non olet · About LEMON Manuals