Stabilizer Bar: Installation
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1990 GMC S15 Pickup, 1990 GMC S15 Jimmy, 1990 GMC Pickup, 1990 GMC Cab & Chassis, and 1990 Chevrolet S10 Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Apply rubber lubricant to insulator bushing contact areas of stabilizer bar. All components must be installed in original location. Install insulator bushings onto bar with bushing slit toward front of vehicle.NOTE: On Astro and Safari models, stabilizer bar must be installed with identification forming on right side of vehicle and with offset of bar installed in downward position.
- Install bushing brackets squarely onto bushings. Loosely install mounting bolts. Tighten bolts to specification. Ensure link bushing assembly nut is even with bottom of bolt. Lower vehicle.