LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1990 >> Step Van 7.4 N, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (SUSPENSION - FRONT ( C Series 2WD)) >> Removal & Installation >> Lower Ball Joint >> Installation

Lower Ball Joint: Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1990 GMC S15 Pickup, 1990 GMC S15 Jimmy, 1990 GMC Pickup, 1990 GMC Cab & Chassis, and 1990 Chevrolet S10 Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position new ball joint in lower control arm bore. Using "C" clamp and Installer (J-9519-16 ), press ball joint into bore until it bottoms on control arm. See Figure . Remove installer tools.
  2. Position grease seal on ball joint so grease purge hole faces inward. Press grease seal on ball joint. Ensure grease seal is fully seated on ball joint. To install remaining components, reverse removal procedure. Lubricate ball joint fitting. Check and adjust wheel alignment.
scientia non olet · About LEMON Manuals