Bushing Replacement (R-P20/2500-30/3500 & G30/3500)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1990 GMC Suburban, 1990 GMC Pickup, 1990 GMC Cab & Chassis, 1990 Chevrolet Suburban, and 1990 Chevrolet Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Components can be changed with control arm in vehicle. To remove components, upper control arm must be disconnected from frame. See UPPER CONTROL ARM in this article. Unscrew bushings and slide control arm shaft out of control arm. Remove inner seals from between bushings and shaft.
- To install, slide new seal onto each end of upper control arm shaft. Install shaft into upper control arm. Adjust shaft until centered in control arm, then tighten bushing nuts to specification. See Fig 1 . Check shaft for free rotation. Install grease fittings and lubricate bushings.