LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1990 >> Step Van 7.4 N, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (SUSPENSION - FRONT ( R Series 2WD)) >> Removal & Installation >> Steering Knuckle >> Removal

Steering Knuckle: Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1990 GMC Suburban, 1990 GMC Pickup, 1990 GMC Cab & Chassis, 1990 Chevrolet Suburban, and 1990 Chevrolet Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support vehicle near ball joint so coil spring remains compressed. Remove wheel and tire assembly. Remove brake caliper, hub and brake rotor assembly. Remove rotor splash shield.
  2. Remove cotter pin and nut from tie rod end. Use Tie Rod Remover (J-6627-A ), to remove tie rod stud from steering knuckle arm.
  3. Support lower control arm with floor jack. Remove upper and lower ball joint cotter pins and loosen ball joint stud nuts. Using Ball Joint Separator (J-23742 ), separate steering knuckle from ball joint studs. See Figure . Remove ball joint stud nuts and remove steering knuckle.
scientia non olet · About LEMON Manuals