Lower Ball Joint: Installation
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1990 GMC Suburban, 1990 GMC Pickup, 1990 GMC Cab & Chassis, 1990 Chevrolet Suburban, and 1990 Chevrolet Pickup. However, it is still accessible from the selected car via links, so may be relevant.
Assemble "C" Clamp (J-951930 ) and Installer (J-9519-16 ) from ball joint remover/installer set to install ball joint. See Fig 1 . To complete installation, reverse removal procedure. Ensure bleed vent in rubber boot is positioned facing forward. Install grease fitting and lubricate new ball joint with chassis lubricant.