Master Cylinder: Installation
WARNING: This page does not describe the selected car, but rather 35 other vehicles, including the 1992 Pontiac Trans Sport, 1992 Oldsmobile Silhouette, 1992 Oldsmobile Bravada, 1992 GMC Yukon, and 1992 GMC Vandura Special. However, it is still accessible from the selected car via links, so may be relevant.
- Bench bleed master cylinder before installing. See MASTER CYLINDER BLEEDING under BLEEDING BRAKE SYSTEM . Position master cylinder on mounting studs. Position combination valve and bracket on mounting studs (if applicable). Loosely install master cylinder retaining nuts. Connect brake lines to master cylinder but DO NOT tighten.
- Tighten master cylinder retaining nuts. Tighten brake lines. Connect brake pedal push rod (if disconnected). Fill fluid reservoir. Bleed brake system. See MANUAL BLEEDING, PRESSURE BLEEDING or VACUUM BLEEDING under BLEEDING BRAKE SYSTEM .