Removal & Installation ("C" & "K" Series)

WARNING: This page does not describe the selected car, but rather 35 other vehicles, including the 1992 Pontiac Trans Sport, 1992 Oldsmobile Silhouette, 1992 Oldsmobile Bravada, 1992 GMC Yukon, and 1992 GMC Vandura Special. However, it is still accessible from the selected car via links, so may be relevant.

Raise vehicle by frame, allowing rear axle to hang free. Remove bracket that covers valve. Remove nut and lever from valve shaft. See Figure. Clean area around brake line fittings at valve. Disconnect brake lines from valve. Remove valve-to-frame bolts and valve.
To install, reverse removal procedure, ensuring rear axle is hanging free and valve is securely bolted to frame when lever is attached to valve (this ensures correct valve adjustment). Bleed brake system. See MANUAL BLEEDING, PRESSURE BLEEDING or VACUUM BLEEDING under BLEEDING BRAKE SYSTEM .