Removal (Sliding Caliper)
WARNING: This page does not describe the selected car, but rather 35 other vehicles, including the 1992 Pontiac Trans Sport, 1992 Oldsmobile Silhouette, 1992 Oldsmobile Bravada, 1992 GMC Yukon, and 1992 GMC Vandura Special. However, it is still accessible from the selected car via links, so may be relevant.
- Remove two-thirds of brake fluid from master cylinder. Raise and support vehicle. Remove wheel. Using "C" clamp or large pliers, compress caliper piston until it bottoms in its bore.
- Disconnect brake hose from caliper. Remove caliper support key bolt. See Figure. Using hammer and brass punch, drive out caliper support key and spring. Remove caliper. Remove inner and outer pads.