LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1990 >> Step Van 7.4 N, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Disc Brake System & Drum Brake System) >> Removal & Installation >> Front Brake Caliper >> Installation

Front Brake Caliper: Installation

WARNING: This page does not describe the selected car, but rather 35 other vehicles, including the 1992 Pontiac Trans Sport, 1992 Oldsmobile Silhouette, 1992 Oldsmobile Bravada, 1992 GMC Yukon, and 1992 GMC Vandura Special. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using wire brush, clean corrosion from machined ways on caliper and caliper mount. Apply silicone grease to these surfaces. Install inner pad and anti-rattle spring on caliper mount. See Figure. Install outer pad in caliper. Place caliper on caliper mount.
  2. Using a hammer and brass punch, install caliper support key and spring. Install caliper support key bolt, ensuring bolt boss fits into circular cutout on caliper support key. Tighten bolt to 15 ft. lbs. (20 N.m).
  3. Connect brake hose to caliper and tighten hose bolt to specification. See TORQUE SPECIFICATIONS  table at end of article. Bleed brake system. See MANUAL BLEEDING, PRESSURE BLEEDING or VACUUM BLEEDING under BLEEDING BRAKE SYSTEM . Install wheel.
scientia non olet · About LEMON Manuals