LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1990 >> Step Van 7.4 N, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Disc Brake System & Drum Brake System) >> Adjustments >> Height-Sensing Proportioning Valve >> "P" Series

"P" Series

WARNING: This page does not describe the selected car, but rather 35 other vehicles, including the 1992 Pontiac Trans Sport, 1992 Oldsmobile Silhouette, 1992 Oldsmobile Bravada, 1992 GMC Yukon, and 1992 GMC Vandura Special. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise vehicle at frame rails, allowing rear axle to hang free. Remove nut and lever from valve shaft. See Fig 2. Select appropriate adjustment gauge (available from manufacturer). Rotate valve shaft to permit installation of gauge.
  2. Install gauge with flat on valve shaft indexed to flat on gauge, and tang on gauge inserted in valve mounting hole. Install lever (DO NOT pull lever onto shaft using nut). Install nut. Break off tang on gauge. Lower and test-drive vehicle.
Fig 1: Height-Sensing Proportioning Valve ("C" & "K" Series)
G91B13756Courtesy of GENERAL MOTORS CORP.
Fig 2: Height-Sensing Proportioning Valve ("P" Series)
G91C13757Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals