Brake Bleeding Procedure
WARNING: This page does not describe the selected car, but rather 151 other vehicles, including the 1992 GMC Yukon, 1992 GMC Vandura Special, 1992 GMC Vandura, 1992 GMC Suburban, and 1992 GMC Sonoma. However, it is still accessible from the selected car via links, so may be relevant.
Brake system may be bled the same as a conventional system. If manual bleeding, wait 15 seconds between strokes. If pressure bleeding, pressurize brake bleeder to 20-25 psi (kg/cm2 ). Brake bleeding sequence is as follows: right rear, left rear, right front, left front, isolation dump valve. Use DOT 3 brake fluid only.