LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1990 >> Step Van 7.4 N, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Removal & Installation - M/T) >> Transmission Removal & Installation >> Except "M" & "S/T" Series >> Installation

Except "M" & "S/T" Series: Installation

WARNING: This page does not describe the selected car, but rather 28 other vehicles, including the 1989 GMC Vandura Special, 1989 GMC Vandura, 1989 GMC Value Van, 1989 GMC Suburban, and 1989 GMC Safari. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check that plugs located in rear of bellhousing below transmission mounting bolt holes are tight and not damaged. Note location before removal. Install new plugs if plugs are damaged.
  2. Apply a light coat of high-temperature grease to main drive gear splines. Place transmission in high gear. Reverse removal procedures to complete installation. Tighten bolts to specification. See TORQUE SPECIFICATIONS (EXCEPT "M" & "S/T" SERIES)  .
scientia non olet · About LEMON Manuals