"M" Series: Installation
WARNING: This page does not describe the selected car, but rather 28 other vehicles, including the 1988 GMC Vandura Special, 1988 GMC Vandura, 1988 GMC Value Van, 1988 GMC Suburban, and 1988 GMC Safari. However, it is still accessible from the selected car via links, so may be relevant.
- Apply a light coat of high-temperature grease to main drive gear splines. Reverse removal procedures to complete installation.
- Braces must be installed with the elongated holes at the transmission end. Tighten brace retaining bolts at the clutch housing first then at the transmission. Tighten bolts to specification. Refer to TORQUE SPECIFICATIONS ("M" SERIES) .