LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1990 >> Step Van 7.4 N, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Removal & Installation - M/T) >> Transfer Case Removal & Installation >> NP-208 (10 & 20 Series) >> Removal

NP-208 (10 & 20 Series): Removal

WARNING: This page does not describe the selected car, but rather 26 other vehicles, including the 1984 GMC Vandura Special, 1984 GMC Vandura, 1984 GMC Value Van, 1984 GMC Suburban, and 1984 GMC S15 Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place transfer case in "4H". Raise vehicle. Drain lubricant from transfer case. Remove cotter pin from shift lever swivel. Mark transfer case front and rear output shaft yokes and drive shafts for assembly alignment reference.
  2. Disconnect speedometer cable and indicator switch wires. Disconnect front drive shaft at transfer case yoke. Disconnect parking brake cable guide from pivot located on right frame rail, if necessary. Remove engine strut rod from transfer case.
  3. Place support under transfer case and remove transfer case-to-transmission adapter bolts. Move transfer case assembly rearward until free of transmission output shaft and remove assembly. Remove all gasket material from rear of transmission adapter housing.
scientia non olet · About LEMON Manuals