LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1990 >> Step Van 7.4 N, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Servicing - M/T) >> Adjustments >> Shift Linkage >> All With Column Shifter

All With Column Shifter

WARNING: This page does not describe the selected car, but rather 28 other vehicles, including the 1989 GMC Vandura Special, 1989 GMC Vandura, 1989 GMC Value Van, 1989 GMC Suburban, and 1989 GMC Safari. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove shift rods from transmission. Place First and Reverse gear selector lever on transmission in Reverse position. Move second and third transmission shift lever to forward detent, then back one.
  2. Place column shifter in Reverse position. Turn ignition switch to "LOCK" position. Move column shifter to Neutral position and put a 1/4" gauge pin through holes in shift levers at base of steering column.
  3. Loosen slide swivel on First and Reverse rod and place transmission shift lever in First and Reverse. Hold tightly in place and tighten swivel adjusting bolt. Install second and third shift rod.
  4. Unlock steering wheel and remove gauge pin. Lubricate all rod and swivel connections.
scientia non olet · About LEMON Manuals