LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1990 >> Step Van 7.4 N, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Servicing - M/T) >> Adjustments >> Shift Linkage >> All With Column Shifter

All With Column Shifter

WARNING: This page does not describe the selected car, but rather 28 other vehicles, including the 1985 GMC Vandura Special, 1985 GMC Vandura, 1985 GMC Value Van, 1985 GMC Suburban, and 1985 GMC Safari. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place gear selector lever in reverse position. Turn transmission shift lever fully clockwise to forward stop. Turn ignition switch to "LOCK" position. Attach primary shift rod to column shift lever with retainer.
  2. Slide swivel on to end of shift rod and insert swivel into transmission shift lever. Loosely assembly with bolt and washer. Turn column shift lever sown as far as possible and tighten bolt.
  3. Turn ignition switch to "UNLOCK" position and move gear selector lever to neutral. Turn transmission shift lever and cross shaft lever clockwise to full forward positions, then back 1 detent to Neutral.
  4. Align gauge holes in column shift levers (3) and insert 1/4" gauge pin through holes. Repeat adjustment procedure with secondary shift rod. Remove gauge pin and check for proper linkage operation. Ignition switch should turn to "LOCK" position with shifter in reverse only.
scientia non olet · About LEMON Manuals