LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1990 >> Step Van 7.4 N, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Servicing - M/T) >> Adjustments >> Shift Linkage >> All With Floor-Mounted Shifter

All With Floor-Mounted Shifter

WARNING: This page does not describe the selected car, but rather 26 other vehicles, including the 1984 GMC Vandura Special, 1984 GMC Vandura, 1984 GMC Value Van, 1984 GMC Suburban, and 1984 GMC S15 Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect all shift rods from transmission shift levers. With shift control lever in Neutral position, insert a 1/4" diameter pin through alignment holes in shifter assembly.
  2. Align both shift levers on the transmission in the forward detent, then back one detent. Loosen lock nuts on shift swivel ends and align rod ends with shift lever holes. Install shift rods in levers, tighten lock nuts and install lock pins.
  3. Remove alignment pin and check for proper linkage operation.
scientia non olet · About LEMON Manuals