LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1990 >> Step Van 7.4 N, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Servicing - M/T) >> Adjustment >> Shift Linkage >> All With Floor-Mounted Shifter

All With Floor-Mounted Shifter

WARNING: This page does not describe the selected car, but rather 26 other vehicles, including the 1983 GMC Vandura Special, 1983 GMC Vandura, 1983 GMC Value Van, 1983 GMC Suburban, and 1983 GMC S15 Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect all shift rods from transmission shift levers. With shift selector lever in neutral position, insert a 1/4" diameter pin through alignment holes in shifter assembly.
  2. Align all shift levers at transmission in neutral position. Rotate transmission output shaft to be sure all levers are in neutral. Loosen lock nuts on shift rod ends and align rod ends with shift lever holes. Install shift rods in levers, tighten lock nuts and install lock pins.
  3. Remove alignment pin and check for proper linkage operation.
scientia non olet · About LEMON Manuals