Wheel Hub & Bearings: Installation
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 1992 Oldsmobile Bravada, 1992 GMC Yukon, 1992 GMC Suburban, 1992 GMC Sonoma, and 1992 GMC Safari. However, it is still accessible from the selected car via links, so may be relevant.
- To install NEW wheel hub stud, lubricate hub bore and install stud. Place 4 washers on stud and install stud nut with flat side to washers. Tighten stud nut to draw stud into hub bore. Remove nut and washers. Install hub and bearing assembly onto drive axle shaft.
- To complete installation, reverse removal procedure. Tighten bolts and nuts to specification. Depress brake pedal several times to extend caliper piston after installation.