"S" & "T" Series: Removal
WARNING: This page does not describe the selected car, but rather 53 other vehicles, including the 1994 GMC Yukon, 1994 GMC Vandura Special, 1994 GMC Vandura, 1994 GMC Sonoma, and 1994 GMC Safari. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect negative battery cable. Remove shift lever boot and slide upward on shift lever. Shift transmission into neutral and remove shift lever bolts at transmission. Remove shift lever.
- Remove parking brake cable for clearance. Raise vehicle and mark drive shaft for reassembly reference. Remove drive shaft. Remove skid plate, if equipped.
- Remove transfer case, if equipped. Disconnect vehicle speed sensor and wiring harnesses as needed. On 4.3L models, purge fuel pressure and disconnect fuel lines at manifold. On all models, disconnect exhaust pipes at manifolds.
- Remove slave cylinder from transmission. Support transmission and remove catalytic converter hanger and support braces. Remove necessary crossmembers.
- Remove transmission-to-engine bolts. On 4.3L models, rotate transmission counterclockwise before pulling over clutch splines. On all models, remove transmission.
NOTE:
DO NOT
allow transmission to hang from clutch.