LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1990 >> Step Van 7.4 N, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Drive Axle - 7.5", 7.625", 8.5" & 9.5") >> Removal & Installation >> Axle Shafts & Bearings >> Installation

Axle Shafts & Bearings: Installation

WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 1990 GMC Vandura Special, 1990 GMC Vandura, 1990 GMC Safari, 1990 GMC S15 Pickup, and 1990 GMC S15 Jimmy. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse removal procedure. Using Bearing Installer (J-34974 for 7 1/2" and 7 5/8", J-23690 for 8 1/2" and J-29709 for 9 1/2" ring gear), install axle shaft housing bearing until bearing installer bottoms against housing shoulder.
  2. Using Seal Installer (J-33782 for 7 1/2" and 7 5/8", J-21128 for 8 1/2" and J-29713 for 9 1/2" ring gear), install axle shaft housing seal until it is flush with outer edge of axle tube. After installing axle shaft and "C" lock, pull axle shaft outward so "C" lock seats in side gear counterbore. Install pinion shaft and pinion shaft lock bolt.
scientia non olet · About LEMON Manuals