Removal & Installation (4WD "C" & "K" Series)
WARNING: This page does not describe the selected car, but rather 58 other vehicles, including the 1992 Oldsmobile Bravada, 1992 GMC Yukon, 1992 GMC Suburban, 1992 GMC Sonoma, and 1992 GMC Safari. However, it is still accessible from the selected car via links, so may be relevant.
- Remove wheel and tire assembly. Disconnect speed sensor electrical connector. Remove speed sensor wire from clip on upper control arm. Remove bolt attaching speed sensor wiring harness to vehicle frame.
- Remove 2 bolts attaching speed sensor to back of steering knuckle. Remove speed sensor. To install, reverse removal procedure. Speed sensor air gap is non-adjustable. See TORQUE SPECIFICATIONS table.