LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1990 >> Step Van 7.4 N, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Suspension - Front (4WD) - Torsion Bar) >> Removal & Installation >> Wheel Hub & Bearing Assembly >> Removal

Wheel Hub & Bearing Assembly: Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1990 GMC S15 Pickup, 1990 GMC S15 Jimmy, 1990 GMC Pickup, 1990 GMC Cab & Chassis, and 1990 Chevrolet S10 Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support vehicle. Remove wheel. Depress brake caliper piston. Detach brake caliper mounting bolts and move aside. Remove disc brake rotor.
  2. Detach dust cover and remove cotter pin, nut retainer, nut and washer. Slide hub/bearing carrier off front axle shaft splines. Inspect steering knuckle grease seal and hub bearing for excessive wear or damage and replace as necessary. If hub wheel stud must be replaced, use Wheel Stud Remover (J-6627-A ).
scientia non olet · About LEMON Manuals