"K" Series
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1990 GMC S15 Pickup, 1990 GMC S15 Jimmy, 1990 GMC Pickup, 1990 GMC Cab & Chassis, and 1990 Chevrolet S10 Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support vehicle with jack stands under lower control arms. Ensure stands are as close as possible to each lower ball joint and upper control arm bumper does not contact frame.
- To check ball joints, place a dial indicator stem against spindle to show vertical movement. Pry between lower control arm and outer bearing race while reading dial indicator. Vertical play should not exceed .080" (2.0 mm).