Intake Manifold: Installation
- Install gaskets on cylinder head, noting rear location of coolant passage restriction and any special instructions included in gasket set.
- Apply 3/16" bead of silicone sealer at front and rear intake manifold mounting surface of cylinder block. See Fig 1. Extend bead of sealer 1/2" up each cylinder head.
Courtesy of GENERAL MOTORS CORP.
- Install intake manifold. Install manifold retaining bolts. Tighten bolts in sequence to specification. See Fig 2. See TORQUE SPECIFICATIONS table. To complete installation, reverse removal procedure.
Courtesy of GENERAL MOTORS CORP.