Cluster Display Does Not Dim With Lights On
- Check for open or shorted parking light power circuit, bad parking light switch, and for an inoperative cluster. Turn parking lights and ignition on.
- Using a DVOM, measure voltage between ground and pin terminal A6 of large 34-pin connector. See Figure. If voltage reading is less than battery voltage, repair open or short in Brown wire. If voltage reading is okay, go to next step.
- Using a DVOM, measure voltage between ground and pin terminal A6 of large 34-pin connector while adjusting panel light dimmer switch from high intensity to low intensity.
- DVOM should read between zero and battery voltage. If not, repair Gray wire and/or replace parking light switch. If no problem found, replace inoperative instrument cluster.