LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1990 >> Step Van 7.4 N, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Steering Column Switches >> Turn Signals & Hazard Flashers >> Removal & Installation >> Turn Signal & Hazard Flasher Switches >> Removal ("P" Series)

Removal ("P" Series)

  1. Remove steering wheel. See HORN BUTTON & STEERING WHEEL in this article. Remove turn signal switch canceling cam and spring. Remove column-to-panel trim plate (if equipped). Disconnect wiring harness half-moon connector. Pry wiring harness protector from harness retaining slots.
  2. Mark location of each wire in half-moon connector. Remove each individual wire from connector using Wire Remover (J-22727). Insert remover into lower end of connector. Push in until remover bottoms.
  3. Pull wire from connector. Withdraw remover. Remove directional signal lever screw. Remove lever. Push in on hazard warning knob while unscrewing it to remove knob.
  4. On models with tilt column and A/T, remove gear selector dial screws. Remove selector dial and indicator. Remove cap and dial illumination light from housing cover. Unscrew and remove tilt release lever.
  5. Using Plate Compressor (J-23653-A), compress lock plate. Pry snap ring from groove. Discard snap ring. Lift off lock plate. See Figure. On all columns, remove 3 signal switch mounting screws. Carefully remove switch assembly from column while guiding wire harness through opening in shift lever housing.
scientia non olet · About LEMON Manuals