Bushing Replacement

Control arm mounted bushings may be replaced using a press. See Fig 1 . Axle housing mounted bushings are removed using Receiver (J-21474-5), Bushing Carrier (J-21474-6), Bolt (J-21474-19) and Nut (J-21474-18). Bushings are installed using Receiver (J-21474-5), Bushing Installer (J-21474-20), Bolt (J-21474-19) and Nut (J-21474-18).

Fig 1: Replacing Control Arm Bushings (Typical)

Courtesy of GENERAL MOTORS CORP.