Shock Absorbers: Installation
- To install shock absorber, reverse removal procedure. If equipped with Electronic Level Control, left air shock has 2 line connections while right shock only has one connection.CAUTION: DO NOT allow vehicle weight to rest on air shock until it has been inflated to at least 10 psi.
- Tighten mounting nuts to specification. Connect air line and add 10 psi (.7 kg/cm2 ) air pressure to prevent shock absorber damage (if equipped).
- On models with Electronic Level Control, turn ignition on and ground compressor test lead to active system and inflate shocks. Test lead is Green connector with Yellow wire located to left of power brake booster.