LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1990 >> Caprice Base, 4.3 Z, 700R4/MD8 >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 5.0L (307") V8 - VIN [Y] >> Removal & Installation >> Engine >> Removal

Removal & Installation: Engine: Removal

  1. Disconnect battery and remove air cleaner. Drain radiator. Disconnect radiator hoses and remove upper fan shroud. Remove fan assembly. Disconnect heater hoses at engine.
  2. Remove power steering pump and lay aside. Remove A/C compressor and lay aside. Disconnect accelerator and throttle valve cable. Disconnect cooler lines at radiator (if equipped). Remove radiator.
  3. Disconnect vacuum hoses. Disconnect Computer Command Control (CCC) wiring harness. Disconnect Air Injection Reaction (AIR) hose at pipe from converter. Remove washer bottle. Disconnect engine wiring harness at bulkhead. Disconnect necessary wires. Remove hood.
  4. Remove distributor cap. Disconnect cruise control cable. Disconnect positive battery cable. Disconnect negative battery cable at A/C hose bracket and alternator bracket. Raise and support vehicle.
  5. Remove crossover pipe and catalytic converter as an assembly. Remove flexplate cover. Remove torque converter bolts. Remove motor mount bolts. Disconnect fuel inlet hose at fuel pump. Disconnect torque converter clutch wiring at transmission.
  6. Disconnect transmission cooler lines at clip on engine oil pan. Remove transmission-to-engine bolts. Lower vehicle. Support transmission. Install lifting device and remove engine.
scientia non olet · About LEMON Manuals