Side Gear (RH) Clutch

Fig. 8 Exploded View Of Eaton Locking Differential. Models With 8 1/2 Inch Ring Gear:

1. Remove shim and disc pack from side gear, keeping components in order.
2. Inspect discs and guide clips and replace as needed.
3. Inspect side gear and shim. If either component is damaged or excessively worn, differential assembly must be replaced. If gear hub is scored or abnormally worn, inspect corresponding bore in case. If case bore is damaged or oversize, differential assembly must be replaced.
4. Assemble eared and splined discs onto side gear hub, starting with eared disc as shown in Fig. 8. If original disc pack is used, ensure that discs are installed in original position.