Side Gear (RH) Clutch

Fig. 8 Exploded View Of Eaton Locking Differential. Models With 8 1/2 Inch Ring Gear:

1. Remove disc pack and shim from side gear, keeping components in order.
2. Clean and inspect components, and replace any that are damaged, deformed or excessively worn. If side gear must be replaced, refer to SIDE GEAR SHIM SELECTION for shim selection prior to case assembly. If side gear hub is scored or worn, inspect bore in case and replace assembly if bore is damaged or worn.
3. Alternately assemble eared discs and splined discs on side gear hub, starting with eared disc as shown in Fig. 8.
4. Install original shim or replacement shim of same thickness if original side gear is being used.