Steering Column - Removal and Installation

Fig. 1 Steering column removal:

Removal
1. On models equipped with airbag, disable airbag system as described under "SERVICE PRECAUTIONS."
2. On all models, disconnect battery ground cable.
3. Disconnect transmission control linkage from column shift tube levers.
4. Remove upper universal joint pinch bolt, Fig. 1, from intermediate shaft. Mark relationship of universal yoke to steering shaft.
5. Remove bracket, then screws from cover and seal. Fig. 1.
6. Remove steering wheel as follows:
a. Remove horn button cap, retainer and steering wheel nut.
b. Remove horn wire lead assembly if equipped, then mark position of steering wheel to steering shaft.
c. Remove wheel with a suitable steering wheel puller.
7. Disconnect column electrical connectors.
8. Rotate column so shift lever clears dash opening and remove.

Installation
1. Insert column through dash opening. guide shaft into universal yoke, lining up marks made at removal.
2. Finger tighten screws and nuts on bracket.
3. Attach upper intermediate shaft pinch bolt and tighten to specifications.
4. Angle of Carden joint must be 34°-39°.
5. Tighten bracket screws and nuts to specifications.
6. Install screws through cover and seal to dash panel.
7. Connect electrical connectors and install steering wheel.
8. Connect transmission control linkage and battery ground cable.
9. Rearm airbag system as described uner "SERVICE PRECAUTIONS."