Mechanical - Hydraulic: Drum: Remove & Replace
WARNING: This page is about the Pickup R10, 4.3 Z, Automatic, 400/M40, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Rear,Full Floating Axle,Inboard Mounted,Separable,Both | 2.2 | B | ||
| Rear,Full Floating Axle,Non Separable,Both | 1.8 | B | ||
| Rear,Full Floating Axle,Non Separable,One Side | 1.0 | B | ||
| Rear,Full Floating Axle,Separable,Inboard Mounted,One Side | 1.2 | B | ||
| Rear,Full Floating Axle,Separable,Outboard Mounted,Both | 1.8 | B | ||
| Rear,Full Floating Axle,Separable,Outboard Mounted,One Side | 1.0 | B | ||
| Rear,Semi-Floating Axle,Both | 0.5 | B | ||
| Rear,Semi-Floating Axle,One Side | 0.3 | B | ||
| Additional Procedure: DRUM: Remove & Replace: | ||||
| w/10 Stud Wheels add (Each) | 0.1 | B | ||
| w/Dual Rear Wheels add (Each Side) | 0.1 | B | ||
| w/Separable Hub add (Each) | 0.1 | B | ||
| Combination Procedure: DRUM (REMOVED): Refinish: DOES NOT include grind hot spots. | ||||
| Each Additional | 0.2 | B | ||
| One | 0.3 | B | ||