LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1987 >> Forward Control 5.7 M, Automatic, 475/M40 >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Suspension - Front) >> Removal & Installation >> Upper Control Arm & Pivot Shaft Bushings >> Removal

Upper Control Arm & Pivot Shaft Bushings: Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1987 GMC Safari, 1987 GMC S15 Pickup, 1987 GMC S15 Jimmy, 1987 GMC Cab & Chassis, and 1987 Chevrolet S10 Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Note location of alignment shims for reinstallation. Remove control arm mounting nuts and shims. Raise and support front end of vehicle under lower control arms, between spring seats and ball joints.
  2. Remove wheel. Remove upper ball joint from steering knuckle. Support rotor and hub assembly to prevent weight from damaging brake hose. It is necessary to remove upper control arm mounting bolts for clearance. Remove upper control arm.
scientia non olet · About LEMON Manuals