LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1987 >> Forward Control 5.7 M, Automatic, 475/M40 >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Suspension - Front) >> Removal & Installation >> Steering Knuckle >> Installation

Steering Knuckle: Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1987 GMC Safari, 1987 GMC S15 Pickup, 1987 GMC S15 Jimmy, 1987 GMC Cab & Chassis, and 1987 Chevrolet S10 Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Insert upper and lower ball joint studs in knuckle and install nuts. Install shield over knuckle seal and onto knuckle. Install tie rod end stud into knuckle bore.
  2. Install Steering Linkage Installer (J-29193 ). Tighten prevailing nuts to 15 ft. lbs. (20 N.m). Remove installer tool. Install stud nut. Install new cotter pin.
  3. Install hub and rotor assembly. Adjust wheel bearings. To complete installation, reverse removal procedure. Check front end alignment.
scientia non olet · About LEMON Manuals