Lower Control Arm & Pivot Shaft Bushings: Installation
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1987 GMC Safari, 1987 GMC S15 Pickup, 1987 GMC S15 Jimmy, 1987 GMC Cab & Chassis, and 1987 Chevrolet S10 Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- To install, reverse removal procedure. Ensure front leg of lower control arm is installed into crossmember before installing rear leg. See Fig 1 .
- Tighten lower control arm pivot bushing nuts with weight of vehicle on the wheels. Tighten all remaining nuts and bolts to specification. Check wheel alignment and adjust as necessary.