With Power Brakes

CAUTION: Brake fluid will damage electrical connections and painted surfaces. Use shop cloths, drip pans and fender covers to prevent brake fluid from contacting these areas.

Removing/Installing Master Cylinder Assembly:

Removal:
1. Remove air cleaner.
2. Loosen tube nuts (15) and disconnect two hydraulic brake pipes.
3. Remove two attaching nuts (16).
4. Remove brace rod (10).
5. Remove master cylinder (14).

Installation:
1. Install master cylinder (14).
2. Install brace rod (19).
3. Torque attaching nuts (16) to 17 Nm (150 in.lb)
4. Attach tube nuts (15) and torque to 11 Nm (100 in.lb)
5. Install air cleaner.
6. Bleed hydraulic system. Refer to Brakes/Service and Repair/Bleeding Procedure. Service and Repair