LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1985 >> Sprint Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (1.3L 4-CYL - VINS [3,5] & 1.6L 4-CYL - VIN [0]) >> Removal & Installation >> Cylinder Head (Sidekick, Swift) >> Removal (Sidekick & Swift)

Removal (Sidekick & Swift)

WARNING: This page is about a different car, the 1990 Suzuki Swift, 1990 Suzuki Sidekick, and 1990 Suzuki Samurai. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release fuel pressure. See FUEL PRESSURE RELEASE  . Label and remove hoses, lines and electrical connectors for intake and exhaust manifold removal. Disconnect exhaust pipe from manifold.
  2. It is not necessary to remove exhaust and intake manifold at this time. Remove timing belt. See TIMING BELT. Discharge A/C system. Remove compressor suction hose from suction pipe (if equipped).
  3. Loosen cylinder head bolts in reverse order of tightening sequence. See Figure . Loosen head bolts in 2 or 3 steps to prevent cylinder head warpage. Remove bolts and cylinder head with intake and exhaust manifolds.
scientia non olet · About LEMON Manuals