LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1985 >> Sprint Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (1.3L 4-CYL - VINS [3,5] & 1.6L 4-CYL - VIN [0]) >> Engine Oiling System >> Oil Pump >> Installation

Oil Pump: Installation

WARNING: This page is about a different car, the 1990 Suzuki Swift, 1990 Suzuki Sidekick, and 1990 Suzuki Samurai. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse removal procedure. Ensure gears are assembled in same direction as originally installed. Apply thin coat of engine oil to inner and outer rotors, lip portion of oil seal and inside surfaces of oil pump case and plate. Install inner and outer rotors.
  2. Install gear plate. Ensure that gears turn freely by hand after gear plate is installed. Install 2 oil pump pins, new dipstick "O" ring, new seal for oil pick-up tube and new oil pump gasket. Use Oil Seal Guide (09926-18210) to prevent damage to oil seal during installation of oil pump.
  3. Apply engine oil to guide and install pump. Install dipstick guide with new seal. Tighten bolts to specification. Install oil pan using silicone type sealant. Tighten bolts to specification.
scientia non olet · About LEMON Manuals